Local Trucking Companies in Atkinson, North Carolina:
We know a few things here very, very well. What we know best is truck drivers and the hiring process. What you see here are some trucking companies from Atkinson, North Carolina. Go ahead and check out the info listed for these companies and their information. Also think about the Apply Buttons you see because what we'll do when you apply is forward your driving history to companies you're pre-qualified to drive for and get better truck driving jobs for any kind of employee, even Student experienced in Reefer. No matter what kind of truck driver you are, or experience you have, we'll work as hard as we can to find awesome truck driving jobs for you to review. Applying with us can change your truck driving career because we only work with truck drivers and helping them find better jobs.
Trucking Companies in Atkinson, North Carolina
Your 10-Codes of the Day
10-13 = Advise weather and road conditions
10-67 = All units comply
10-35 = Confidential Information
10-77 = Negative Contact
10-2 = Receiving Well
Your Truck driving Definitions of the Day
Walking Beam Suspension
Type of truck and tractor rear suspension consisting of two beams, one at each side of the chassis, which pivot in the center and connect at the front to one axle of a tandem and at the rear to the other axle.
Common Carrier
Freight transportation company which serves the general public. May be regular route service (over designated highways on a regular basis) or irregular route (between various points on an unscheduled basis).
LTL Carrier
Trucking company which consolidates less-than-truckload cargo for multiple destinations on one vehicle. (see TL Carrier)
Break
I'd like to break-in, interrupt
Gear Ratio
Number, usually expressed as a decimal fraction, representing how many turns of the input shaft cause exactly one revolution of the output shaft. Applies to transmissions, power takeoffs, power dividers and rear axles. Example: If 2.5 revolutions of an input shaft cause one revolution of the output shaft, the gear ratio is 2.5:1.